Hello Everyone,
One of my users was complaining the vacancy (infotype 1007) was not getting updated to open when terminating the employ through termination organiser(PC00_M13_CTO3) where as, there is vacancy popup coming up when termination is done through PA40 even the Infotype 1007 gets set to open.
On further analysis found that the vacancy control FM(standard SAP program) checks for batch input before proceeding with calling the vacancy popup, since the termination organiser is set as batch input it is not calling the vacancy pop-up.
If anyone has experienced a similar requirement or any suggestions for updating the infotype 1007 from termination organiser, would be much appreciated.
Regards,
Prashanth